Every home has been plastered at one point of its existence. Plaster, which is a good-looking and durable material, is a very practical step towards home beautification and improvement. This article lists several beginner tips that you can consider when you decide to do the plastering work. By following these tips, you will see that plastering is quite easy if you know how to do it properly.

Following are five plus one beginner tips for plastering walls:

Make Sure That the Wall is Clean and Ready to Be Plastered

If you want the plastering to be effective, then it is recommended that you make sure to prepare the surface that will receive the treatment. This includes the removal of dirt, dust, and other material that stains the surface you are working on. Checking the suction of the wall is also important. This is because it bonds your plaster to the wall. You should check whether the wall has a low or high level of suction. A low suction wall makes the plaster struggle to bond to the surface while a high suction wall soaks up moisture very quickly. You can check the wall suction via the patch test.

Always Mix by Adding Plaster to the Water and Not the Other Way Around

There is one important thing to keep in mind when mixing the plaster mixture: add plaster to the water rather than doing it the other way around. You might think that it is not very important and will have a minimal effect on the mixture. The truth is, if you add water into the mixture, chances are high that mixture will have lumps in it. This can negatively affect the quality of the plaster as the mixture won’t be evenly distributed and mixed.

Start on a Small Area to Get the Technique Right

If you are a beginner to plastering, then it is highly recommended that you do not bite more than you can chew. What this means is that you shouldn’t be trying to plaster the entire room at once because it could turn what should be a satisfying job into a bad experience. That’s why it is recommended that you start in a small area to get the technique right. Start with just one surface at a time and leave the larger walls until last. Know in advance exactly what you want to achieve that day and plan accordingly.

Apply Two Coats

You need to apply two coats if you want to achieve the desired results. Applying two coats of plaster will leave you with a nice finish. For the first coat, apply a very thin layer and make sure to push it into the wall. Make sure the coat does not fall off later by using sufficient pressure. After applying the first coat, lightly scratch the new plaster via a wire scratching brush. After that, apply the second coat. When applying the second coat, focus on the right thickness and make sure it is flat all throughout.

Follow the Six Stages of Plastering

There are six stages of plastering and each of them is equally important. So, you must follow all the stages if you want to get good results in the end.

Following are the six stages of plastering you should follow:

Stage 1: Apply the first coat of plaster and make sure it is not more than 2mm thick.

Stage 2: Once you notice that the plaster is starting to firm up, use a clean trowel to flatten off the first coat. This will ensure that the bulges are pushed out.

Stage 3: Stage 3 is all about applying the second coat of plaster. It is recommended that you use half the plaster that you did in the first coat. The thickness should be half as well.

Stage 4: In this stage, use the trowel to make the plaster flat and remove any holes. Apply more plaster for holes that aren’t getting filled.

Stage 5: Use firm pressure with your trowel in order to smoothen any ridges in the plaster but be careful not to scrape the plaster off.

Stage 6: In the final stage, use your trowel once again over the entire wall with a firm pressure to finish.

Bonus Tip: Using the Right Plastering Trowel is Crucial

Using the right plastering trowel or hawk is crucial because it can make or break the finish of the job. Trowels come in a wide range of shapes and sizes that are specialized depending upon the application requirements. A small trowel will make a simple, larger job take a lot longer than it should. On the other hand, a trowel that is too big will not fare well on the walls that have uneven surfaces. So, if you are new to plastering, then it is recommended that you use a smaller trowel that is not more than 11-inch in size.

These are some of the beginner tips that will help you. If you are not confident then you can always hire professionals for the job. Look for plasterers near me to find the professionals you are looking for.

Then when your plaster is completely dry on your walls it’s time to hang pictures and art on the walls. When done correctly, this will make your home feel great as you will get to appreciate all your favourite pictures in every room!